BK Radio GPH Flex•Mode User Manual

GPH Owner’s Manual 25
Master
Clone
Master
Switch
CLONING PROCEDURE
STANDARD INSTRUCTIONS
Any “master” radio (a GPH Flex•Mode™ with the desired radio frequencies
and settings) is capable of transferring its program to another GPH
Flex•Mode™ or “slave” radio. The radio receiving the program is also
referred to as the “clone.” The LAA0700 cloning cable will be required in
the following procedure.
1. MAKE SURE the battery packs for both
radios are charged.
2. ATTACH THE MASTER SWITCH END of the
cloning cable to the side connector of the
master radio.
NOTE: One plug of the cloning cable has a
push-button master switch. This
plug must be attached to the master
radio.
3. TURN ON THE MASTER RADIO.
4. SELECT THE GROUP to be cloned from the
master radio.
5. PUT THE MASTER RADIO IN PROGRAMMING
MODE
by pressing and holding the master
switch. Enter the password of the selected
group. The display shows “
PRG Ch 0.”
6. REVIEW THE VALUES in the program. Any
required changes must be made now.
7. CONNECT THE OTHER PLUG of the cable to
the side connector of the radio you want to
clone.
8. TURN ON THE CLONE and set it to the
desired channel group.
PRG
ch
0

BK Radio GPH Flex•Mode Specifications

General

Brand	BK Radio
Model	GPH Flex•Mode
Category	Portable Radio
Language	English