26 BK Radio
9. PRESS THE * KEY on the master radio
keypad. The display will flash “PROG”
signifying that the radio is ready to
download its program to the clone.
10. PRESS THE FCN KEY on the master radio
keypad. The program in the master will
then be downloaded to the clone. The clone
will automatically send back the program to
the master to verify a successful cloning.
11. I
F THE DOWNLOAD WAS SUCCESSFUL, the
display on the master will resume flashing
“PROG”.
• To clone the other channel group, turn
off both radios and go back to Step 3 on
the previous page, changing the channel
group as required.
• If cloning is finished, turn off the clone
and disconnect the cloning cable.
Normal radio operation will occur when
you turn on the clone.
12. I
F THE DOWNLOAD WAS NOT SUCCESSFUL,
the master will display “FAIL” and multiple
beeps will follow. Failure of downloading
can be due to:
• Improper connection
• Failure to turn on the clone
• Setting the clone in programming mode
NOTE: To stop the “FAIL” mode, press CLR,
turn off both radios, and try again,
starting with Step 1 on the previous
page.
PRG
P
R O G
1 2 3
5 6
7 8 9
0
*
#
CLR
FCN
PRI
ENT
1
2
3
4
5
6
7
8
9
0
*
#
CLR
FCN
PRI
ENT
PRG
F A I
To Next Page
Loading...
Need help?
General
