37
3.1 General
Your boat is designed to be powered with a 4-cycle
outboard motor. 4-cycle outboard engines do not
use an oil injection system and are not equipped
with a remote oil tank. They have an oil sump in
the crankcase that must be kept full of the type
of oil recommended by the engine manufacturer.
The oil must be checked before each use and
changed regularly.
Each manufacturer of the various outboard mo-
tors provides an owner’s information manual
with its product. It is important that you read the
manual(s) very carefully and become familiar with
the proper care and operation of the engines and
drive systems. A warranty registration card has
been furnished with each new engine and can be
located in the engine owner’s manual. All infor-
mation requested on this card should be lled out
completely by the dealer and purchaser and then
returned to the respective engine manufacturer
as soon as possible.
DO NOT ATTEMPT TO SERVICE ANY ENGINE OR DRIVE
COMPONENT WITHOUT BEING TOTALLY FAMILIAR WITH
THE SAFE AND PROPER SERVICE PROCEDURES. CERTAIN
MOVING PARTS ARE EXPOSED AND CAN BE DANGEROUS
TO SOMEONE UNFAMILIAR WITH THE OPERATION AND
FUNCTION OF THE EQUIPMENT.
DO NOT INHALE EXHAUST FUMES! EXHAUST CONTAINS
CARBON MONOXIDE THAT IS COLORLESS AND ODORLESS.
CARBON MONOXIDE IS A DANGEROUS GAS THAT IS
POTENTIALLY LETHAL.
3.2 Drive System Corrosion
The outboard motor is a complete drive system
with the gear case being just forward of the
propeller and connected to the power head with
a vertical drive shaft. All engines require some
maintenance. Routine maintenance recommended
for your engine is outlined in the engine owner’s
manual. Routine maintenance is normally the
primary concern unless the boat is to be kept in
Chapter 3:
saltwater for extended periods of time. Then the
main concerns are marine growth and galvanic
corrosion.
Marine growth occurs when components are left
in the water for extended periods and can cause
poor performance or permanent damage to the
exposed components. The type of growth and how
quickly it occurs is relative to the water conditions
in your boating area. Water temperature, pollu-
tion, current, etc. can have an eect on marine
growth.
Galvanic corrosion is the corrosion process oc-
curring when dierent metals are submerged
in an electrolyte. Seawater is an electrolyte and
submerged engine components must be properly
protected. Outboard motors are equipped with
sacricial anodes to prevent galvanic corrosion
problems. The anodes must be monitored and
replaced as necessary. For locations and mainte-
nance, please refer to the engine owner’s manual.
When leaving the boat in the water, tilt the motor
as high as possible. This will decrease the risk of
marine growth around the cooling inlets, propel-
ler and exhaust ports or damage from galvanic
corrosion.
Outboard Power System
PROPULSION SYSTEM
To Next Page
