Blackfin 272CC - Page 64

64
Electrical System
Windshield Vent
A three position momentary switch that activates
the electric ram that opens and closes the wind-
shield vent panel. The middle position is o. Press
and hold the top of the switch to open the vent.
Press and hold the bottom of the switch to close
the vent. The switch automatically returns to the
o position when it is released.
Wiper
Activates the windshield wiper.
Windlass
A three position momentary switch that controls
the windlass. The middle position is o. Press
and hold the top of the switch to raise the anchor.
Press and hold the bottom of the switch to lower
the anchor. The switch automatically returns to
the o position when it is released.
Livewell Pump
Activates the pump that supplies seawater to the
livewell.
Livewell Lights
A three position switch that activates the white
or blue livewell lights. The middle position is o.
Press the top of the switch to activate the white
livewell light. Press the bottom of the switch to
activate the blue livewell light.
Port Macerator (Optional)
Activates the diaphragm pump that drains the
port shbox.
Starboard Macerator (Optional)
Activates the diaphragm pump that drains the
starboard shbox.
Notice:
Toavoiddamagetotheshboxpumps,al-
ways monitor the water level as the pump
drainstheshboxandturnitoimmediately
when draining is complete.
Raw Water Pump
Activates the seawater system pump that sup-
plies the raw water washdown hose connector in
the cockpit. The pump is the pressure demand
type. A pressure switch automatically controls
the water pump when the system is activated and
properly primed.
Fresh Water Pump
Activates the fresh water system pump that sup-
plies the fresh water washdown hose connector
in the cockpit and at the windlass. The pump is
the pressure demand type. A pressure switch
automatically controls the water pump when the
system is activated and properly primed.
ACC 1
Reserved for additional DC accessories installed
by you or your Blackn dealer.
ACC 2
Reserved for additional DC accessories installed
by you or your Blackn dealer.
ACC 3
Reserved for additional DC accessories installed
by you or your Blackn dealer.
ACC 4
Reserved for additional DC accessories installed
by you or your Blackn dealer.
Additional DC Switches and Panels
Trim Tab Switch Panel
Located in the helm. This switch panel controls
the trim tab planes located on the transom of the
boat. It is protected by a circuit breaker in the
DC Panel. Refer to the Helm Control Systems
chapter for detailed information on the operation
of the trim tab controls.
Engine Trim and Tilt Switches
Located in the helm. These switches are typically
installed in the engine throttle and shift controls.
They control the trimming and tilting of the en-
gines. Refer to the Helm Control Systems chapter
and the engine owner’s manual for additional in-
formation and the proper use of the tilt and trim
switches.
12 Volt Receptacles
Provide electrical current for portable 12 volt
equipment. Receptacles are typically located in
the helm storage compartment and in the bow
seat area. The circuit breakers that protect the
receptacle circuits are located in the battery switch
panel.