Blackfin 272CC - 11.6 Helm Seats & Bait Prep Station

98
Exterior Equipment
Helm Seats In The Seat Position
Helm Seats In Leaning Post Position
Cockpit Table & Pedestal Store In Head Compartment
To use the table, remove the table and pedestal
from the head compartment. Pull the safety pin
in the side of the mounting bracket and insert the
pedestal base rmly in the bracket, then release
the pin and make sure it extends into the pedestal
base to secure the pedestal to the base. Then
install the table on the pedestal. Reverse the
process to remove the table.
The table should only be used while running at
slow speeds, at the dock or at anchor. Always
remove and properly stow the table and pedestal
before operating the boat above slow speed. To
prevent damage to the table or head compart-
ment, make sure to secure the table with the
rotating latch when it is stored in the mounting
brackets. Also make sure the pedestal is securely
fastened to the brackets.
11.6 Helm Seats & Bait Prep Station
Helm Seats
The helm seats are equipped with a ip up bolster
to provide more room between the seats and the
helm. The bolster converts the seat to a leaning
post style seat with a backrest, allowing the opera-
tor and passenger to sit or stand at the helm. To
convert each seat to a leaning post, lift the front
of the seat cushion to raise the bolster and push
it back above the seat cushion.
Arm rests on each side provide a more comfortable
driving position and swing up into the backrest
cushion to make it easier to enter and exit the
helm area.
A molded in footrest on the rear of the console
makes the helm more comfortable when the bol-
sters are set to the seat position.
Bait Prep Station
A bait prep station equipped with a sink, cutting
board, tackle storage, drawers and a slide out
cooler is located aft of the helm seats. The sink
is plumbed to the fresh water system and has a
removable spray head that reaches to each side of
the station or can be used as a shower. The sink
is drained by gravity to a thru-hull tting in the
hull side. Grab rails, cup holders, and a cutting
board are built into the top of the station.