3 Download the latest version of the Cintel Scanner software from the
Blackmagic Designwebsite, install it on your computer and run it. The Cintel
Setup utility will detect your computer is plugged into your Cintel Scanner’s
USBrecoveryport. Click ‘update now’.
Cintel Scanner software will detect your computer
is plugged into Cintel’s USB recovery port
4 After the update recovery is complete, your Cintel Scanner should now be running
thelatest software and operating normally. You can check this by disconnecting the
USB cable, connecting the thunderbolt cable, and then power cycling your scanner.
5 Replace the rear panel and reinstall your Cintel Scanner into position for normal
operation. If you need further assistance, you can always visit the Blackmagic Design
forum, or reach us via the Blackmagic Design support center.
116Help
To Next Page
Loading...
Need help?
General