Blackmagicdesign Mini Converter Sync Generator - Updating Mini Converter SDI Distribution 4 K

Updating Mini Converter SDI Distribution 4K
Blackmagic Mini Converter SDI Distribution 4K has an internal USB connector. This mini
converter has no user adjustable settings, so you will never need to connect setup software.
Very occasionally, though, internal software updates will be released to improve compatibility.
For example, Blackmagic Converters Software version 7.0.9 improves this mini converter’s
compatibility with level A 3G SDI signals.
If a particular update applies to the equipment you are using with Mini Converter
SDIDistribution 4K, follow these steps to access your mini converter’s USB connector:
NOTE Make sure you disconnect power before accessing your Mini Converter
SDIDistribution 4K. We recommend this job is undertaken by a qualified engineer
using an anti static strap.
SDI Distribution 4K
SDI OUT
SDI OUT
SDI OUT
SDI OUT
SDI IN
POWER
+12V
SDI OUT
SDI OUT
SDI OUT
SDI OUT
Auto Switching SD, HD and Ultra HD
1 2
Using a philips head screwdriver, remove the four
(M3) screws on the sides ofMiniConverter SDI
Distribution 4K.
Slide off the external cover.
3 4
Using a T10 torx screwdriver, remove the
four screws connecting the circuit board to
MiniConverter SDI Distribution 4K’s frame.
Gently pull the circuit board from the frame to
access the USB connector.
Installing Administration Software 10