Mini Switch Settings Example
Experiment with the switches by setting your Blackmagic Mini Converter to de-embed SDI
audio channels 1 and 2 and output to analog by setting switches 8, 4, 3 and 2 to the
OFF position.
SDI Audio Selection Table
Audio Channels Switch 4 Switch 3 Switch 2 Switch Diagram
1 and 2 OFF OFF OFF
3 and 4 OFF OFF ON
5 and 6 OFF ON OFF
7 and 8 OFF ON ON
9 and 10 ON OFF OFF
11 and 12 ON OFF ON
13 and 14 ON ON OFF
15 and 16 ON ON ON
Blackmagic Converters Setup Settings
The Converters Setup utility can be used to change settings and update your Mini Converter’s
software. You can access these settings by moving between the ‘video,’ ‘audio,’ and ‘about’
tabs. The ‘about’ tab is detailed in the ‘changing settings’ section in this manual.
The ‘video’ tab for Mini Converter SDI to HDMI 6G contains the following settings.
The ‘clip video output to legal levels’ setting is checked by default.
This ensures that your HDMI video output stays within legal levels.
Blackmagic Mini Converters 38
To Next Page
Loading...
