Switches
Mini Converter UpDownCross HD’s switches provide the following settings :
Switch 1 - Processing Off - Processing On
When switch 1 is set to OFF all conversions are bypassed and the converter can be used to
distribute your video via both SDI and HDMI outputs.
With switch 1 set to OFF the SDI and HDMI outputs match their corresponding inputs.
When switch 1 is set to ON, processing is enabled and switches 4 to 8 configure the
converter’s output.
Switch 2 - Level A and Level B 3G-SDI
When switch 2 is set to OFF the converter outputs level B 3G-SDI. When set to ON the
converter outputs level A 3G-SDI. This provides compatibility with other SDI equipment that
uses level A or level B 3G-SDI.
TIP If you have connected a 3G-SDI signal to 3G-SDI equipment and the signal is not
being detected, try changing the setting for switch 2 as the equipment you’re
connected to may be using an alternate SDI level.
Switches 4 - 8
Switches 4 to 8 determine the format and standard of the converter’s output signal. Theswitch
configuration for each format and standard is shown on the table on the base of the unit.
Mini Switch Settings Example:
Blackmagic Mini Converters 93
To Next Page
Loading...
