3.3 Electrical installation
For safe and trouble-free operation of the Blade
®
countertop dispense appliance,
the following instructions on electrical connection must be observed:
Before connecting the Blade
®
countertop draught system appliance, compare
the connection data (voltage and frequency) on the rating plate with those of
your mains power supply. This data must correspond in order to avoid damage
to the appliance. If in doubt, consult a qualified electrician.
The socket must be secured at least 10A fuse or higher (Max. 16 A). Ensure that
the power cord is undamaged and is not laid over hot surfaces or sharp edges.
The power cord must not be pulled tight.
The electrical safety of the appliance is only assured when it is connected to a
properly installed protective earth (PE) conductor system. Connection to a mains
socket without PE conductor is forbidden. If in doubt, the electrical system must
be checked by a qualified electrician. The manufacturer assumes no liability for
injury or damage caused by a missing or interrupted protective earth conductor.
The appliance can be damaged in situations where the electrical grid (i.e. the network
delivering electricity to outlets) is unreliable and of poor quality. In case the electrical
grid is not delivering the required power quality a voltage stabilizer must be installed.
3.4 Set-up and assembly of the appliance
Place the appliance on a stable tabletop or counter.
Screw the tap handle shaft into the thread of the turning mechanism located on
the right of the dispense tap and pull tight using the spanner provided (Figure 4).
Now push the tap handle onto the rod as far as it will go. Align the tap handle
with the front of the appliance (Figure 5).
Using the screwdriver located on the tool, the grub screw on the underside of the
handle is screwed into the handle such that it can no longer be rotated (Figure 6).
■
■
■
■
■
CAUTION
The appliance can be lifted by the tap but not on the tap handle.
►
■
■
■
■
To Next Page
Loading...
