Blade 9930 - Removing or Replacing Empty Kegs

Operation and use
19
4.5 Removing or replacing the empty keg
When removing the empty keg, perform the following working steps:
Disconnect the keg from the appliance by turning the switch (C) upwards to
set the keg locking to “Unlock“ ( ) (Figure 35). The indicator light (D) flashes
red for around 2 seconds (10 seconds if the keg is not empty) and the locking
mechanism audibly move backwards (Figure 36).
Remove the dome (I) (Figure 37).
Flip down the tap cover (K) (Figure 38).
Remove the inline dispensing valve (M) from the holder of the dispense tap (F)
and remove the beer tube (L) from the retainer (Figure 39).
Now remove the keg (Figure 40).
NOTE
The keg is empty in case the beer flow stops while the tap is open.
If dome light is on when keg will unlock the light brightness will be reduced
as long as the new keg is locked or dome light will switched off
.
►
►
■
■
■
38
3
37
3
2 sec.
36
3
■
■
40
4
39
4
NOTE
Dispose of the empty container in an environmentally-friendly manner.
►