Blade 9930 - Appliance Switches Overview; Optimum Dispensing Techniques

Operation and use
18
4.3 Switches
There are three toggle switches on the appliance.
The main switch (B) on the right of the appliance (Figure 34).
The keg locking switch (C) with indicator light (D) on the control panel (Figure 35).
The dome lighting switch (E) for the effect lighting on the control panel
(Figure 35).
4.4 Optimum dispensing
To ensure optimum dispensing, perform the following steps:
When dispensing, avoid the spout will touching the beer or foam in order to
prevent residues affecting the quality of the head.
Fully open the tap in one continuous movement, otherwise too much foam will
form in the glass.
Dispense the beer and close the tap when glass is full.
CHEERS!
The volume gauge is set to full when a new keg is installed and indicates the amount of
beer remaining. The flow time is measured via a microswitch and the corresponding
amount is deducted from the full volume.
■
■
■
E
C
D
35
3
B
34
3
NOTE
Use glasses that are clean, cool and rinsed with fresh water.
►
■
■
■
NOTE
Rinse out the glasses with fresh cold water before using them again. This
ensures a longer-lasting head and prevents the formation of excess foam.
►