Safety
5
1 Safety
This section contains important safety instructions for handling Blade
®
countertop draught system appliance. This appliance complies with the
prescribed safety regulations. Improper use can however result in
personal injury and/or appliance damage.
1.1 Danger of electric current!
Danger to life by electric current! Contact with live wires or
components could lead to serious injury or even death!
Observe the following safety precautions to avoid electric shocks:
If the supply cord is damaged, it must be replaced by a special cord
or assembly available from the manufacturer or its service agent!
Do not open the housing of the appliance. Danger of electric shock if
live connections are touched and/or the electrical and mechanical
configuration is changed.
The voltage of the power source must be the same as specified on
the rating plate!
Before use check that the appliance functions properly!
The appliance should not be used if:
- the power cord is damaged
- the appliance shows noticeable damage
- the appliance has been dropped
Connect the appliance only to AC current and to a socket with
earthing contact. Do not pull the cord over sharp edges, clamp it into
place or allow it to hang down! Keep the cord away from hot and
damp areas!
Only insert the mains plug when the appliance is switched off!
The appliance must not be operated with a timer nor a remote
control system. If an extension lead is required, use only an earthed
cord with a conductor cross-section of at least 1.5 mm
2
!
Do not use this appliance near bathtubs,
showers, basins or other vessels containing water.
If the appliance falls into water, remove the mains plug immediately.
Under no circumstances reach into the water when the appliance is
still connected to the power supply!
Do not place the appliance or the power cord on hot surfaces e.g.
cooker or similar or in the vicinity of open flames!
The installation of a faulty current protective appliance with a rated
breaking current offers you additional safety by ensuring that 30 mA
will not be exceeded in the house installation. Let your installation
electrician advise you!
►
►
►
►
►
►
►
►
►
►
►