Blade 9930 - Connecting to Power Supply; Mounting the Drip Tray

3.5 Connecting the appliance to the power supply
The appliance is now connected to the power supply as follows:
Tilt the appliance around 30° to the right and feed the appliance side of the power
cord into the socket located on the underside of the appliance (Figure 7+8).
Now connect the power cord to the power supply.
(See 3.3 Electrical Installation).
3.6 Mounting the drip tray
Position the drip tray base (S) with the drip tray cover (R) centrally in front of the
appliance. Then push it gently forwards until it engages in the operating position
(Figure 10+11).
■
NOTE
Appliance is already pre-connected with a power cord.
►
CAUTION
Ensure that this plug connection is secure.
The base of the appliance must not be placed on top of the cord, as this
would make it impossible to guarantee the secure positioning of the appliance.
After unpacking the appliance or in case of plug changing or appliance tilting, wait
for 8 hours before turning the appliance on
(Figure 9).
►
►
►
■
■
7
8
8 h
9
10
click!
11
1
Putting into operation
12