BMP-320 Operating Manual
Initial Operation
Before start-up the operating personnel must be familiar with the
safety regulations given in this manual.
; Put the scarifier and the filter unit on the surface to be treated.
In order to move the machine manually, manipulate the quick lift
as described in chapter 3.5.
; When machine is in place set the quick lift into down position
and arrange the depth adjustment by the handwheel so the flails
just slightly touching the ground. Job depending adjustment
needs to be done after the start up procedure as described in
the following paragraphs. (Initial Operations 5.2) Set the quick
lift back into the upwards position.
; Check the main power cable and the dust hose for damage.
Replace or repair all damaged parts before starting the machine.
; Connect the scarifier and the filter unit with the dust hose. Use
hose clamps at the connections.
; Connect the electric cable of the scarifier with the site supply (only
by electric driven units).
; Connect the electric cable of the filter unit with the site supply.
3
To Next Page
Loading...
