Operating Manual BMP-320
Maintenace
Assembly:
1 Clean the main shaft and lubricate it uniform
2 Push the scarifying drum on the drive shaft until it hits its heel.
3 Fit back the side plate and pay attention to have the correct
position to avoid damaging the bearing that’s located in the side
plate.
Never use the scarifier without a side plate fitted or incorrect
fitted plate.
7.7 Influence on the pattern of the scarifier
The scarifying pattern depends on the surface being treated the
change of working depth, tool selection and selected speed will
mostly have influence on the result.
Depending on the required surface structure you will have to change
the tools (Flails) .
In order to get the best result compare the individual results of the
tools. Do your testing having the same speed selection in order to get
comparable visual results.
A check on the scarifying pattern should always being done after
new or other types of tools have been fitted. Just that way efficient
work is possible, will prevent from unnecessary wear and repair
cost’s.
7.8 Synchronous
Prior to any repair works on the machine and its drives,
secure the machine against unintentional switching-on. Put
the machine to its safety off position. Chapter 2.5
Synchronous data
See O.P. Spare parts
8
To Next Page
Loading...
