Operating Manual BMP-320
Operation
6.1 Operation
Normal start-up and operation of the scarifier BMP-320 isn’t different
from the procedure described in Chapter 5 “Initial operation”.
Carry out scarifying operation in parallel tracks in such a way that the
dust hose and electric cable do not become twisted.
Figure 6.1 shows the recommended scarifying paths leading away
from the filter unit.
Make sure that no vehicles, such as forklift trucks and other
equipment run over the electric cable and the dust hose.
The selection of the correct speed of the scarifier is important for a
good result. In the case that the surface has different characteristics
(e.g. different hardness or different coating thickness), a uniform
result can be achieved by varying the speed during operation.
6.2 Rate of Feed Information
Speed adjustment depends on conditions and the required surface
profile of the surface to be treated.
Observe the surface in order to set the correct speed and vary the
speed dependent on the required penetration depth and profile
achieved.
2
To Next Page
Loading...
