BMP-320 Operating Manual
Initial Operation
; Check the turning direction of the drive motor. See the turning
direction marking on the motor.
(Not necessary by motors with internal combustion engine.). In
case of wrong turning direction turn the phase inverter in the
plug.
; Let down now the scarifier with the quick lift.
; Dependent on the surface to be treated, you can adjust now
the scarifying depth with the handwheel until you have reached
the required surface profile.
; Readjust the machine by the handwheel if it runs harshly.
Adjusting the machine so it starts vibrating or hammering
hardly means you have to reduce the depth adjustment by the
handwheel. Keep going without readjusting means to have a
negative effect on the material of the machine. It does not
generate more performance.
; By pushing the machine you can treat the surface without effort
The advancing speed is dependent on the conditions and the
required surface profile of the surface to be treated.
5
To Next Page
Loading...
