Blaupunkt New Orleans MP58 - Radio Mode Tuning; Waveband and Station Selection; RDS and Regional Function Control

59
ENGLISH
Switching REGIONAL on/off
Note:
This setting is only possible in radio
mode.
Press the MENU•OK button 5.
Press the
or button 4 repeat-
edly until "TUNER MENU" appears on
the display.
Press the
button 4 to open the
menu.
Press the
or button 4 repeatedly
until "REG" appears on the display.
"OFF" or "ON" is displayed alongside
"REG".
To switch REGIONAL on/off,
press the
or button 4.
When you have fi nished making your chang-
es,
press the ESCAPE button ;.
Switching the convenient RDS function
on/off
To switch the RDS functions AF and
REGIONAL on or off,
press and hold down the TRAF button
3 for longer than 2 seconds.
The display briefl y shows the selected set-
ting "RDS ON" or "RDS OFF".
쏅
쏅
쏅
쏅
쏅
쏅
쏅
Selecting the waveband/memory
bank
This device can receive programmes broad-
cast over the FM frequency range as well as
the MW and LW (AM) wavebands. There are
three memory banks available for the FM
waveband (FM1, FM2 and FMT) and one
for each of the MW and LW wavebands.
Six stations can be stored in each memory
bank.
To switch between the FM memory banks
(FM1, FM2 and FMT) and the MW and LW
wavebands,
press the BND button <.
Tuning into a station
There are various ways of tuning into a
station.
Automatic station seek tuning
Press the
or button 4.
The radio tunes into the next receivable
station.
Note:
If the priority for traffi c information is
active (the display shows the traffi c
jam symbol), the next traffi c informa-
tion station is set.
Tuning into stations manually
You can also tune into stations manually.
Note:
You can only tune into stations manu-
ally if the convenient RDS function and
PTY are deactivated.
쏅
쏅
Radio mode
02_NewOrleansMP58_gb.indd 5902_NewOrleansMP58_gb.indd 59 07.12.2007 14:57:23 Uhr07.12.2007 14:57:23 Uhr