90
INTRODUCTION NAVIGATION RADIO CD / MP3 CD CHANGER SETUP APPENDIX
Installation
The installation menu contains all the necessary items for testing the TravelPilot
E1/E2 and preparing it for operation.
Installation test
The installation test allows you to check whether the system is correctly receiv-
ing signals from the sensors.
Note: The test must be carried out with the ignition switched off.
1 Switch off the ignition and turn on the device using button 3.
Note: If necessary, enter the numerical code.
2 Press and hold down the MENU button ? for longer than 2 seconds.
✔ The installation menu appears in the display.
3 Mark and confirm the INSTallation TEST menu item.
✔ The installation test menu appears in the display.
Note: The installation test does not need to be carried out in order to
calibrate the device. You can start automatic or manual calibration
right away. The purpose of the test is only to check the connections.
You can test the following device functions and connections:
●
GPS - Check the GPS antenna
If the system detects that the GPS antenna is connected, OK appears in the
display. If the system receives a signal from one or more satellites, the number
of received satellites and signal strength will appear. Align your antenna so
that both values are at a maximum.
●
REVERSE - Reversing light connection
When you engage the reverse gear, the arrow display changes from
to .
INST. TEST
AUTO CALIB
MAN. CALIB
ins=all
NAV
T
MC
GPS 7 35
REVERSE
IGNIT. ON
SPEED 5528
INS=ALL =es=
NAV
T
MC
To Next Page
Loading...
