Blaupunkt TravelPilot Rome NAV55E - Operating the navigation system; Specifying Route Options

68
In the "Options" menu, mark and
confi rm the "Traffi c ahead" menu
item.
The distance display appears.
Use the menu button < to set
the length of the blocked dis-
tance, starting with the vehicle
position.
Press the OK button =.
The route is recalculated so that
you evade the blocked section.
The navigation system saves this
blocked section until it is switched
off for longer than 30 minutes.
Before you can block a new route
section, you may have to release the
blocked section again as follows:
In the "Options" menu, mark and
confi rm the "Traffi c ahead" menu
item again.
The confi rmation dialogue "Cancel
traffi c ahead?" is displayed.
Mark and confi rm "Yes" to re-
lease the blocked section of the
route.
➜
➜
➜
➜
➜
Specifying Route Options
You can adjust the route type to
your requirements at any time – be-
fore as well as during the destina-
tion guidance. For this purpose, you
must change to the "Route options"
menu as follows:
Press the NAVI button > for ap-
prox. 2 seconds.
Or:
Mark and confi rm the "Options"
menu in the navigation display.
The Options menu of the naviga-
tion system appears.
In the "Options" menu, mark and
confi rm the "Route options" menu
item.
The "Route options" menu ap-
pears.
Note:
The defi ned route options remain
active until you change them.
➜
➜
➜
Traffic ahead
47,96 km
Traffic ahead
No
Cancel traffic ahead?
Yes
Options
Route options
Traffic ahead
Route list
Route options
Dynamic
Enable
Adjust optimum
Optimum
Fast
Short
Operating the navigation system
ROMENAV55Eman_star_ois_eng.indd 68ROMENAV55Eman_star_ois_eng.indd 68 06.12.2005 16:04:38 Uhr06.12.2005 16:04:38 Uhr