Blaupunkt TravelPilot Rome NAV55E - Operating the radio; Waveband and Memory Bank Selection; Tuning into Radio Stations; Automatic Station Tuning

36
Selecting the waveband/
memory bank
The radio can receive the following
wavebands:
FM: 3 memory banks
(FM1, FM2, FMT)
MW: 1 memory bank
LW: 1 memory bank
To toggle among the memory banks
or wavebands:
Press the TUN button ? repeat-
edly until the desired waveband
or the desired memory bank is
displayed.
Or:
In the radio display, select the
"Band" menu.
In the "Band" menu, confi rm and
select the waveband or the mem-
ory bank.
The selected waveband or the
selected memory bank E is dis-
played.
The previously set station in this
waveband is played.
•
•
•
➜
➜
➜
You can now do the following:
Searching for stations in this
waveband (see below),
calling up stored stations from
this memory bank (see p. 40),
storing stations on this memory
bank (see p. 39).
Tuning into a station
You can adjust stations either auto-
matically (see below) or manually
(see p. 37).
Setting stations automatically
To perform an automatic station
seek tuning:
While the radio display is shown,
press the OK button = for 2 sec-
onds.
Or:
In the radio display, select the
"Tune" menu.
The tuning menu with frequency
band A, station name B and fre-
quency C is displayed.
Note:
To initiate automatic station seek
tuning during a destination guid-
ance, see p. 66.
•
•
•
➜
➜
TUN
FM1
FM2
FMT
MWLW
TUN
FM1
FM2
FMT
MWLW
FMT
16:13
TMC
14
E
FMT
16:13
TMC
14
E
BBC
I 92 I 93 I 94 I
Tune
B
A
C
BBC
I 92 I 93 I 94 I
Tune
B
A
C
Operating the radio
ROMENAV55Eman_star_ois_eng.indd 36ROMENAV55Eman_star_ois_eng.indd 36 06.12.2005 16:03:49 Uhr06.12.2005 16:03:49 Uhr