Blaupunkt TravelPilot Rome NAV55E - Installation instructions; Establishing Device Power Connection

75
CAUTION!
Do not connect the power cable
to terminal 15 (switched posi-
tive) or terminal 30 (continuous
positive)!
6 Illumination connection
For vehicles with adjustable instru-
ment lighting (positive controlled)
7 Positive connection switched via
ignition
CAUTION!
This connection must be con-
nected as switched via ignition
(terminal 15, +12 V)!
8 Ground connection
Cable cross section min. 1.5 mm
2
.
Do not connect the ground wire to
the negative pole of the battery, but
to a suitable ground location, such
as a screw or plate of the body.
Connecting the device
Establishing the power
connection
Check whether the radio con-
nection of your vehicle is already
protected with a 10-A fuse at the
factory (see vehicle operating in-
structions or fuse box).
➜
➜
➜
If the radio connection is protected
by a 10-A fuse:
CAUTION!
Risk of damage to the
device!
If you connect vehicle connectors
directly to the device, it may dam-
age the device. This also applies to
pre-fabricated ISO connectors.
Use only vehicle-specifi c adapter
cables from Blaupunkt.
Connect the vehicle-specific
adapter cable 1 to the vehicle
connector 2 and to chamber
A 5 on the rear side of the de-
vice.
If the radio connection is not pro-
tected by a 10-A fuse:
Connect the negative wire to the
negative pole of the battery.
Connect the positive wire to the
positive pole of the battery via
a 10-A fl oating fuse so that the
10-A fl oating fuse is at a maxi-
mum distance of 30 cm from the
positive pole of the battery.
➜
➜
➜
➜
A
1
2
3
5
4
Installation instructions
ROMENAV55Eman_star_ois_eng.indd 75ROMENAV55Eman_star_ois_eng.indd 75 06.12.2005 16:04:48 Uhr06.12.2005 16:04:48 Uhr