Blaupunkt TravelPilot Rome NAV55E - Installation instructions; Installing Device in Tray; Initial Code Number Entry

78
Bend over as many tabs as pos-
sible using a screwdriver.
Insert the device into the tray to
one-third of its length.
Loosen the screw 1 above the
gyroscope 2 on the right side of
the device.
Adjust the gyroscope with a hol-
low hexagon wrench so that the
marking is in the vertical posi-
tion.
➜
➜
➜
➜
Note:
The maximum setting range is
between –10° and +30°.
Retighten the screw 1.
Installing the device in the tray
Ensure that all connectors are
correctly inserted and the lateral
latching tabs are engaged.
CAUTION!
Danger of damage, risk of
incorrect settings!
If you touch the controls on the
control panel while inserting the
device, they may be damaged.
The device could switch on and
subsequent entries are interpreted
as incorrect entries of the code. The
device is subsequently blocked.
Touch the control panel only at
the edges while inserting it.
Push the device into the tray until
it engages and is retained by the
lateral tabs.
The device should now be installed
in the following position:
Right/left: min. –5° /max. +5°
Front/rear: min. –10°/max. +30°
Entering the code number
If you switch on the device for the
fi rst time after its installation (see
p. 9), you must enter the code (see
p. 21).
➜
➜
➜
➜
Installation instructions
ROMENAV55Eman_star_ois_eng.indd 78ROMENAV55Eman_star_ois_eng.indd 78 06.12.2005 16:04:53 Uhr06.12.2005 16:04:53 Uhr