Blodgett BLCT User Manual

Troubleshooting
Error Code 40
The IO board temperature has been too high.
Steps
Check list
Solution
1
-
Clean the filter at the
bottom of the panel.
Note that this is a warning. If
the temperature continues to
rise, the oven will stop and
display error code 16.
Error Code 41
The steam generator temperature sensor is too hot. The main contactor
has been disconnected.
Steps
Check list
Solution
1
-
Contact HOUNÖ service.
Error Code 42
A software defect has been detected during operation. The steam
generator was activated by mistake.
Steps
Check list
Solution
1
-
Contact HOUNÖ service.
Error Code 45
There is no 24VAC. Main contactor output is not working.
Steps
Check list
Solution
1
Check fuse F1.
48 SERVICE MANUAL

Blodgett BLCT Specifications

General

Brand	Blodgett
Model	BLCT
Category	Oven
Language	English