BC14G AND BC14E
2 --- 1
STANDARD CONTROLS
1
4
3
2
6
7
5
8
10
9
11
FIGURE 1
CONTROLS IDENTIFICATION
1. MODE SELECTOR SWITCH --- turns power to
theovenonoroff.AllowsselectionofSteam,
Hot Air, Combi or Cool Down Modes.
2. TEMPERATURE DIAL --- used to set the cook-
ing temperature in all modes. In the Steam
mode, the temperature must be set to less
than or equal to 212_F (100_C).
3. STEAM INJECTION TIMER --- used to set the
time for the steam injection cycle.
4. STEAM ON DEMAND SWITCH --- u s e d t o i n i -
tiate steam injection cycle.
5. TIMER DIAL --- used to set desired cook time.
6. FAN SPEED SWITCH --- used to select low or
high speed.
7. FLUSH/DRAIN SWITCH --- used to flush/drain
the steam generator for decalcification. The
oven must be off and the steam generator
must be below 160_F(71_C) for this switch to
work.
8. FILL LAMP --- illuminated until the steam gen-
erator is filled with water.
9. TEMP LIGHT --- illuminated until the tempera-
ture setting on the dial has been reached.
10. STEAM LAMP --- illuminated when steam is
being added to cooking process.
11. ON LIGHT --- illuminated when the oven is
turned on in any mode.
To Next Page
Loading...
