Maintenance
34
Troubleshooting Guide
POSSIBLE CAUSE(S) SUGGESTED REMEDY
SYMPTOM: Heating elements do not come on.
S Oven not plugged in.
S Power switch on the control panel is off.
S Control set below ambient temperature.
S Doors are open.
S Computerized controls --- error code on display.
S Plug in electrical supply cord.
S Set the control panel to COOK or OVEN ON.
S Set to desired cook temperature.
S Close doors.
S *
SYMPTOM: Oven does not come to ready.
S The oven has not reached preheat temperature.
S Fan delay feature may be activated, if applicable.
S Internal problem with main temperature control.
S Wait for oven t o reach preheat temperature.
S Deactivate fan delay feature.
S *
SYMPTOM: Convection fan does not run.
S Oven is not plugged in.
S Oven is not set to the cook mode.
S Circuit breaker tripped.
S Fan delay feature may be activated, if applicable.
S Doors are open
S Plug in electrical supply cord.
S Set the control panel to COOK or OVEN ON.
S Reset the breaker.
S Deactivate fan delay feature.
S Close doors.
SYMPTOM: General baking problems.
S Computerized controls --- incorrect product
programming.
S Thermostat out of calibration.
S Reprogram control per Operation section.
S *
*Denotes remedy is a difficult operation and should be performed by qualified personnel only. It is recommended, however, that
All repairs and/or adjustments be done by your local Blodgett service agency and not by the owner/operator. Blodgett cannot as-
sume responsibility for damage as a result of servicing done by unqualified personnel.
WARNING!!
Always disconnect the power supply before cleaning or servicing the oven.
To Next Page
Loading...
Need help?
General
