Installation
8
Oven Assembly
4" (10CM) LEG ATTACHMENT
1. Lay the oven on its side.
2. Screw one leg into each of the corner nuts.
Figure 6
CASTER INSTALLATION
NOTE: Casters are not supplied for the 4" (10cm)
legs, 5Ć3/4" (15cm) or 7" (18cm) stands.
NOTE: Install the locking casters on the front of
the oven. Install the nonĆlocking casters on
the back of the oven.
1. Insert the caster into the leg. Secure the caster
to the leg by tightening the locknut.
Figure 7
OVEN LEVELING
After assembly, the oven should be leveled and
moved to the operating location.
1. The oven can be leveled by adjusting the feet
or casters located on the bottom of each leg.
ADJUSTMENTS ASSOCIATED WITH INITIAL
INSTALLATION
Each oven, and its component parts, have been
thoroughly tested and inspected prior to shipĆ
ment. However, it is often necessary to further test
or adjust the oven as part of a normal and proper
installation. These adjustments are the responsiĆ
bility of the installer, or dealer. Since these adjustĆ
ments are not considered defects in material or
workmanship, they are not covered by the Original
Equipment Warranty. They include, but are not
limited to:
D calibration of the thermostat
D adjustment of the doors
D leveling
D tightening of fasteners.
No installation should be considered complete
without proper inspection, and if necessary, adĆ
justment by qualified installation or service perĆ
sonnel.
To Next Page
Loading...
Need help?
General
