Operation
16
Blodgett IQT Phase IV Control
Programming the PreAlarms:
A PreAlarm is an alarm that sounds during the
cook cycle. PreAlarms can be used to alert the op -
erator that the product needs to be turned or
stirred, etc. Up to three PreAlarms can be pro-
grammed for each product.
1. The top display reads A1__.(The__indicate
the product key) The bottom display gives the
alarm time. Use the product keys to enter the
desired time for the first alarm. Press the EN-
TER KEY (14) to enter the PreAlarm time.
NOTE: PreAlarm times are measure d from th e
end of the total cook time. For example
if the total cook time is 30:00 and a
PreA larm o f 5 : 00 is e nt e re d, the ala rm
will sound 25 minutes into the cook
cycle. If a PreAlarm of 0:00 is entered,
no additio na l PreA larms may be pro-
grammed for the selected product key.
2. Press the SCAN KEY (15).
3. The t op display reads AUTO . The bottom dis-
play reads either YES or no. Press the
TOGGLE/CLEAR KEY (11) to toggle between
YES and no. Press the SCAN KEY (15) to enter
the PreAlarm type.
NOTE: An auto PreAlarm sounds for approxi-
mately 5 seconds, then shuts off auto-
matically. For manual PreAlarms the
operator must press the product key
to silence the alarm.
4. The top display reads A2__. Repeat s teps 1---3
for the second and third PreAlarm. When all
PreAlarms have been entered the control ad-
vances to programming the head count.
Programming the Head Count:
1. The t op display reads HEAd. The bottom dis -
play gives the current number of heads pro-
grammed for this product key. Use the prod-
uct keys to enter the desired number of heads
f r o m 1 --- 9 9 .
2. Press the SCAN KEY (15). The programming
forthisrecipeisnowcomplete.
Exiting the programming mode:
1. The t op display reads Prod. Press the PROG
KEY (10). The control returns to operating
mode.
To Next Page
Loading...
