34
AT6020
i. There is a heavy and light spring pressure setting. Be sure that all Residue Managers
are set on the same pressure setting.
ii. Lift up on the Residue Managers to gauge pressure if settings are the same, but
you suspect the spring pressure is different.
iii. See recommended setting for your residue type and climate above
c. Sealer Blade Hanger Position
i. Check to make sure all sealer blade hanger brackets are mounted on the sealer
arms in the same positions (all front, all back, or all offset)
ii. Check to make sure all sealer blade hanger brackets are mounted on the same
width position (either all narrow or all wide)
iii. See recommended setting for your residue type and climate above
d. Sealer Blade Angle
i. Check to see that the blades on each row are set at a similar angle
ii. Check to see that the backs of the blades on each row are set approximately the
same distance apart.
iii. See recommended settings for your residue type and climate above
e. Baskets
i. Check to see that all baskets are running on the same pressure setting.
ii. Ensure that all baskets freely spin and some are not signicantly more restricted
compared to others.
iii. See recommended setting for your residue type and climate above
f. Knives
i. Lift the implement out of the ground and ensure knives are identical in make and
model
ii. If the implement has been used before, check to make sure wear characteristics
on the knives are similar.
6. If you have checked all settings and still do not see uniformity across the rows, or you have tried
different settings and cannot achieve a strip like those described above, call 800.658.3127 for
additional assistance.
Setting the Implement for eld operation:
BLU-JET StripTill Implement
To Next Page
Loading...
