JUST POWER ON12
Danger
In case of fire, power off the system if it is safe to do so.
Use carbon dioxide, FM-200, or ABC dry powder fire extinguisher.
Remind firefighters to avoid contact with high-voltage components
to prevent the risk of electric shock.
Overheating may cause the battery to deform and leak corrosive
electrolytes or toxic gas. Keep away from batteries to avoid skin
irritation and chemical burns.
(b)Eye Contact: Immediately flush eyes with water for at least 15 minutes, do not
rub eyes, and seek medical attention immediately.
(c)Skin Contact: Immediately wash the infected area with soap and water and seek
medical attention immediately.
(d)Ingestion: Seek medical attention immediately.
• Use the battery within the temperature range specified in this manual.
• Do not expose the battery to humidity or corrosives, as this may cause the battery
to rust, corrode and leak chemicals.
• Do not turn the battery upside down or tilt it.
• Do not ignore warning signs on parts or products made by the manufacturer.
• If the battery exceeds its warranty period, please cease its usage and properly
dispose of it according to your local regulations.
1.3.3 Installation Requirements
•
Do not use batteries with compromised packaging.
• Make sure the battery switch is in the OFF position.
• Tighten the screws securely and conduct regular checks.
• Prevent the positive and negative terminals of the battery from touching each
other or any metal objects to avoid heat generation or electrolyte leakage.
• After installing the equipment, remove unused packing materials such as foam,
carton, plastic and excess cables from the equipment area.
Fire Emergency Measures
•
•
•
•
To Next Page
Loading...
