JUST POWER ON76
Why can't I connect to the EP760 energy storage system via Bluetooth?
(1) Check if the IoT controller is installed correctly and working properly (top light
always on, bottom two lights flashing alternately).
(2)Make sure that the App has access to the Bluetooth on your phone.
(3)Turn on Bluetooth on your phone.
(4)Make sure the app has access the location on your phone.
Why can't I remotely connect to the EP760 energy storage system?
(1) Check if the IoT controller is installed correctly and working properly (top light
always on, bottom two lights flashing alternately).
(2)Make sure that the EP760 energy storage system is configured with WiFi.
(3)Double-check if you entered the correct password.
(4)Check if the WiFi is operating in the 2.4GHz frequency band.
Why is there no output from the BACKUP?
(1) Check if the "AC Switch" on the App is turned on.
(2) If the B500 batteries have no power and are not charging from the grid or
solar system, the output will be automatically turned off.
How long does it take to start the EP760 energy storage system?
The startup time may vary slightly depending on the startup method, but it
should not exceed 3 minutes.
Can I connect a solar system that exceeds the PV input limits of EP760 ESS?
Will the EP760 ESS automatically adjust the input current?
It depends on the voltage of your solar system. The EP760 ESS can handle a
solar system with a voltage range of 150V-500V and supports up to 3 PV inputs
with a total power of 9000W (3000W each channel). It automatically adjusts the
input current within these limits, with a maximum current limit of 12.5A.
Can household appliances be run on solar power while the solar panels are
charging the batteries?
Yes, the EP760 ESS prioritizes solar power for running household appliances,
and any extra energy is used to charge the battery. If you enable the "Feed to
Grid" in the App, any surplus can be sent back to the grid.
12. FAQs (Frequently Asked Questions)
Q1:
A1:
Q2:
A2:
Q3:
A3:
Q4:
A4:
Q5:
A5:
Q6:
A6: