EasyManua.ls Logo

BMG Labtech FLUOstar Omega - Page 6

BMG Labtech FLUOstar Omega
29 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Omega Operating Manual BMG LABTECH
6/29 0415B0001G 2014-05-16
Luminescence - Limit of detection 20 amol / well ATP
- Spectral range 240 ... 740 nm
- Dynamic range: 9 decades
Fluorescence polarization - Limit of detection: <5 mP SD at 1 nM fluorescein
- Spectral range: (ex. and em.): 380 ... 740 nm (900 nm opt.)
- Dynamic range: 4 decades
Absorbance Spectrometer based - Spectral range 220 ... 1000 nm
- Full spectrum captured in < 1 s/well
- Selectable spectral resolution: 1 nm, 2 nm, 5 nm, 10 nm
- OD range: 0 to 4 OD
- Accuracy: < 1% at 2 OD
- Precision: < 0.5% at 1 OD and < 0.8% at 2 OD
AlphaScreen
®
- Limit of detection: < 100 amol / well (384)*
- AlphaScreen
®
and AlphaLISA
®
possible
Computer interface - USB 2.0 or USB 3.0
Power requirements - 100-240 V, 50/60 Hz, max peak 300 VA
- Consumption:
Instrument off: 0 W
Normal operating conditions: 25 W
Normal operating conditions, incubation set to 37
o
C: 60 W
- Fuses: T5A/250V (use original spare fuses provided by BMG
LABTECH only)
Dimensions - Height: 31 cm, width: 44 cm and length 48 cm
Weight - 29 kg
Ambient conditions - Operating temperature: 15°C to 35°C
- Storage temperature: -10°C to 50°C
- Humidity of atmosphere: 20% to 80%
- Non-condensing
Instrument conformity - Over voltage category II; contamination class II; protection class I
Options - Stacker for 50 microplates and optional barcode reader
- ACU: Atmospheric Control Unit to regulate both O
2
(1-19%) and
CO
2
(0-20%) inside the microplate chamber
- Gas Vent: Passive purge gas vent to replace the atmosphere in the
microplate chamber
- Fan Cover: improved control of microplate ambient conditions,
especially for long- term incubation experiments
- LVis Plate with 16 low volume microspots (2µL) for e.g. DNA
concentration measurements
- LVis Plate with additional absorbance quality control standards
(approximate values of 0.1, 0.3, 0.6 and 1.0 OD); one holmium oxide
filter for wavelength accuracy
Limit of detection was calculated according to the IUPAC standard: 3 x (SD
blank
)/slope
* Limit of detection < 100 amol of biotinylated and phosphorylated polypeptide (P-Tyr-100 assay kit,
PerkinElmer, #6760620C), measured in white 384 small volume microplates (17 µL/well)
AlphaScreen
®
and AlphaLISA
®
are registered trademarks of PerkinElmer, Inc.
Specifications are subject to change without notice.

Related product manuals