BMG LABTECH Omega Operating Manual
2014-05-16 0415B0001G 7/29
2 Safety Information
2.1 Description of Warnings
The warning signs used throughout this manual adhere to the description set forth in DIN 4844-2.
A general warning calls attention to a condition which is further described and must be strictly
followed by the operator.
Warning for optical radiation
2.2 General Information
This instrument must be installed and used as outlined in this Operating Manual.
Installation, service and any operation which requires opening of the instrument must be
performed only by trained and certified personnel from BMG LABTECH. Failure to comply
with these instructions will invalidate the warranty and can lead to unsafe operation of this
equipment.
The area designated for the instrument should be free of dust, liquids and acidic vapor. The
surface of the table should be flat and even. Avoid areas subject to vibrations and direct
sunlight.
Prior to turning on the instrument the first time, let the instrument adapt to room temperature
for at least 3 h to avoid condensation which can cause a short circuit. BMG LABTECH will
void the warranty if damage occurs to electrical and/or mechanical parts in cases where the
instrument was turned on before the recommended accommodation time.
Handling and operation of the equipment must be carried out only by qualified personnel and
staff trained by an official BMG LABTECH representative.
Microplates and related accessories (e.g. LVis Plate) operated at temperatures higher than
55°C must cool down below 55°C before being handled and removed from the instrument.
Samples and reagents, be it in solid, liquid, or gaseous form, must be removed from the
instrument immediately after measurement to avoid corrosion and accumulation of hazardous
substances inside the instrument.
To Next Page
Loading...
