Need help?Do you have a question about the BMPRO JHub and is the answer not in the manual?
General| Display | 10.1-inch |
|---|---|
| Connectivity | Wi-Fi, Bluetooth |
| Operating System | Android |
| Resolution | 1280 x 800 pixels |
| Processor | Quad-core |
| RAM | 2 GB |
| Storage | 16 GB |
| Battery | 6000 mAh |
| Weight | 500 g |
Lists the items included with the JHub Tablet product.
Identifies and explains the physical components of the JHub Tablet device.
Accesses app settings, functions, and the owner's manual.
Indicates the Bluetooth pairing status between JHub Tablet and ControlNode.
Controls Sleep Mode and allows temporary activation of loads.
Controls the caravan's slide-in/out mechanism.
Controls the hot water heater.
Controls the water pump.
Indicates the battery charging, discharging, or idle status.
Visually displays the battery's power capacity.
Monitors water levels of up to 4 tanks and their status.
Indicates available external power sources for charging the battery.
Displays battery charging/discharging current and output current.
Displays temperature measured by a wired sensor.
Integrates and monitors gas bottle, tyre, and temperature sensors.
Step-by-step guide to establish Bluetooth connection between devices.
Navigates to settings to configure battery capacity and profile.
Details setting battery profile (Lead-Acid or LiFePO4).
Explains J35 entering Sleep/Storage Mode due to low battery.
How enabling Sleep Mode affects load control.
How enabling Storage Mode affects load control.
Operation and safety precautions for slide-in/out control.
Step-by-step guide to pair the gas bottle level sensor.
Steps to add a new tyre pressure sensor to the system.
Instructions for physically installing the tyre sensor.
Describes what happens when tyre sensor pairing fails.
Steps to remove a paired tyre pressure sensor.
Steps to add a new temperature sensor to the system.
Choosing where to assign the temperature sensor.
How to power the temperature sensor on and off.
Confirmation of successful temperature sensor pairing.
Steps to remove a paired temperature sensor.
Shows how to access the menu to find settings.
Navigates to the specific settings for sensors.
Configures minimum and maximum thresholds for sensors.
Displays how warnings appear when limits are exceeded.
Troubleshooting issues related to the JHub App and tablet.
Explains why app icons might not respond.
Explains causes of text misalignment on the display.
Information on the maximum number of connectable SmartConnect devices.
Troubleshooting common battery detection issues.
Explains ControlNode LED flash codes and their meaning.
Guide to accessing tablet settings to change date and time.
Explains the JHub app behavior when Sleep Mode is active.
Explains JHub app behavior when Low Voltage Mode is active.
Troubleshoots and explains loss of Bluetooth connection.
Troubleshooting steps for pairing issues with the JHub Tablet.
Verifies tablet location settings for pairing.
Clears app cache to resolve potential pairing problems.
Explains issues when pairing is done via tablet settings, not app.
Troubleshoots inability to scan for ControlNode devices.
Diagnoses why the pairing status icon appears red.
Lists technical specifications for the JHub Tablet.
Guidelines for maintaining warranty validity and protecting user rights.
To Next Page