BOCI BLT641 - Page 4

To Next Page

To Previous Page

BLT641 Product Manual

1.1 Schematic diagram of product structure ........................................................................................................................... 20

1.2 Replace the upper protective lens ..................................................................................................................................... 22

1.3 Replace the lower protective lens ...................................................................................................................................... 23

Appendix B - Mechanical Dimensions ................................................................ 24

1.1 Cutting head installation size .............................................................................................................................................. 24

BOCI

Main Page

Table of Contents3
Product Description5
Product View5
Technical Parameters6
Meaning of LED Indicator7
Gas Interface8
Water Cooling Interface9
Electrical Interface10
Bus System11
Non-Bus Systems12
Cutting Head Installation13
Preparation before Operation13
Specific Operation Process14
Preparation of Clean Bench14
The Cutting Head Is Placed in the Clean Workbench14
Clean and Wipe the Fiber Interface of the Cutting Head15
Check the Laser Fiber End Face15
Tear off the Protective Film/Remove the Protective Cap15
Insert the Laser Fiber Interface into the Cutting Head16
Wrap and Seal16
Mount the Cutting Head on the Backplane17
Installing the Ceramic Body and Nozzle18
Beam Centering19
Appendix A - Maintenance21
Schematic Diagram of Product Structure21
Replace the Upper Protective Lens23
Replace the Lower Protective Lens24
Appendix B - Mechanical Dimensions25
Cutting Head Installation Size25

BOCI BLT641 - Page 4

Table of Contents

Related product manuals