30
Normal operation of the shot clock keyboard
1/ Press START / STOP (1) to satrt the countdown of the shot clock.
Press again to stop the countdown.
At the end of the countdown (when the possession time reaches 0)
a sounding signal is started for a duration of 3 seconds.
The LED of the keyboard turns red when the shot clock is
stopped and green when the shot clock is counting down.
2/ Pressing the RESET 24s (2) or RESET 14s (8) key for few
seconds causes the shot clock LED panel and the LCD display
of the keyboard to turn o (blank). The initial value of the timer
(24 sec or 14 sec depending on which key was pressed) is
restored when the key is released.
3/ Pressing the CLEAR (3) key causes the keyboard LCD display
to show - - and the shot clock panel to blank. Pressing this key
again allows the displaying of the current countdown value without
aecting the running of the timer.
4/ Pressing the HORN (4) stops the horn when its is blown
automatically when the countdown reaches 0. This key does not
turn on the horn.
Modify the current possession time
1/ Press the START / STOP (1) key to stop the timer.
2/ Press the C (6) key.
The LCD display and the led of the keyboard start blinking.
3/ Press the PLUS + (5) key to increment by 1 second the current possession time.
This value cannot exceed the stored RESET value (24 sec by default).
4/ Press the MINUS - (7) key to décement by 1 second the current possession time.
5/ Press the C (6) key again to go back to the normal mode.
Recover possession time
1/ If the RESET 24s (2) key is pressed by mistake then press the CLEAR (3) key within the following
2 seconds to recover the previous time.
Modify the preset value of the possession time (default: 24 seconds)
1/ Press the START / STOP (1) key to stop the possession time timer..
2/ Hold down the CORRECTION (6) key of the possession time keyboard for 3 seconds.
The Shot clock displays and the keyboard LCD display are blinking. The value displayed is the currentRESET value.
3/ Press the + (5) key to increment the current RESET value (99 sec. max.).
4/ Press the - (7) key to decrement the current RESET value.
5/ Press the CORRECTION (6) key to come back to normal model.
This parameter is not saved in case of a power failure or if the keyboard is unplug at the end of the game.
Luminosity adjustment of BT6002 display
1/ Press the + (5) key during 3 seconds.
2/ Press the + (5) key to increase the luminosity.
3/ Press the - (7) key to decrease the luminosity.
4/ Press the C (6) key to go back to normal mode.
No backup of this parameter, if the power is cut or when unplugging the keyboard at the end of the match.
4
1
2
3
6
5
7
8
4
1
2
3
6
5
7
8
To Previous Page
Loading...
Need help?
General