Bodet Style 12 User Manual

21
C
Stainless steel
nut HU M8
Stainless steel 8 mm
tooth washer
Stainless steel
screw H M8x25
C
C
Horizontal mounting
Vertical mounting
Pole
D
D
D
St. steel screw ST F M5-40
Cover for single sided mounting
St. steel 6 mm flat washer
Stainless steel nut HM5
Pole
5) Attach the pole to the wall with four 8
mm threaded rods plus chemical sealing
(recommended).
6/ Attach the double sided frame to the polewith
the two 8 mm screws (detail C). Do not forget to
feed the cables through the pole.
7/ Open the clock and remove the wall mounting
parts.
8/ Attach the clock to the double sided frame
on the 4 screws ST F M5-40 (detail D). Place
the 6 mm washers (detail D) on the frame
(and not inside the clocks) to move the clocks
sufciently far away and facilitate insertion of
the cables. Screw in the 2 nuts at the top (D)
without tightening, move the clock away and
insert the cables.
9/ When the cables are correctly positioned,
tighten the 4 nuts (D) of the clock .
Recommendation for installation in «right ag»
1) When leaving our factory the Style 12E and Style 12SE HF radio models are equipped with a
radio antenna mounted on the right ank.
By default, the installation of the antenna on the right ange is suitable for wall mounting on «left
ag» bracket.
2) In the case of mounting as «right ag,» it is essential to swap the right side with the left in
order to install the bracket (see page 19 to remove the anges).
Antenna
Mounted on the
right flank
Antenna
Mounted on the
left flank
Reverse the right flank with the left flank

Bodet Style 12 Specifications

General

Brand	Bodet
Model	Style 12
Category	Clock
Language	English