30
IX - Test menu
A brief self-test (on and off) is carried out automatically on exiting the conguration menu.
A more complete test can be carried out on request.
To start this test, press the “+” for 3 seconds
This test displays :
1) The software version number,
2) Total light-up for 3 seconds,
3) Total switch-off for 3 seconds,
4) The current operating mode (“Ind”, “Min”,”1/2 M” or “Afn” depending on the model) for
2 seconds.
■ If the mode is “Ind”
Case 1 :
No antenna detected : end of the test, return to normal display.
Case 2 :
Antenna detected, not recognized :
1) “Ant” displayed for 2 seconds,
2) dynamic reception : “0:00” displayed, the ”:” ash as the bits are decoded
and then the digits are displayed as they are received.
3) After 10 minutes : end of the test, return to normal display.
You can exit this test mode by pressing the “+” key.
Case 3 :
Antenna recognized :
1) recognized antenna type (“FldC” or “MSF”) displayed for 2 seconds,
2) dynamic reception : “0:00” displayed, the ”:” ash as the bits are decoded
(idem LED of the antenna) and then the digits are displayed as they are
received.
3) After 10 minutes : end of the test, return to normal display.
You can exit this test mode by pressing the “+” key.
■ If the mode is “Min” or “1/2M”
End of the test, return to normal display with the “:” that remains constant until the
reception of the following pulse.
■ If the mode is “AFn”
1) black display with the “:” that remains constant for 3 seconds.
2) dynamic display of received messages.
3) upon reception of 3 coherent and consecutive messages or after a minute:
end of test.
To Next Page
Loading...
Need help?
General
