BodorWelder Fiber Laser User Manual-V1.1
Bodor Inc.
or too loose, and there is no delay when the wire is fed (usually no need to adjust);
2.2.3. Cover the cap once adjusted
3. Installation of wire feeding wheel
3.1 There are two wire feeding wheels in total, two sides are different models,
corresponding to different core diameters, please be sure to install corresponding,
such as the installation of 1.2 welding wire, the wire feeding wheel marked 1.2 side
on the outside;
3.2 When installing, be sure to stick the welding wire in the card slot and then
clamp it.
4. Installation of wire feeding tube
To Next Page
Loading...