BodorWelder Fiber Laser User Manual-V1.1
Bodor Inc.
the up and down keys. Please keep the running state when using;
5.2. Manual wire feeding: After holding down, the wire feeder starts to feed, and
the manual wire feeding speed depends on the background setting;
5.3. Manual pumping: After holding down, the wire feeder begins to pump back,
and the manual pumping speed depends on the background setting.
5.4. After all Settings are completed, click to save;
5.5. Set the wire feed speed of the page as the default wire feed speed, that is,
after changing here, the switch still remains unchanged;
5.6. Startup delay: not set by default;
5.7. Withdrawal length and filling length: set according to actual use;
When the wire feed is stopped, the system will first pump back a certain distance
and then a certain distance in the wire feed, this function is mainly used for breaking
the wire;
When the wire is still outside at the beginning of each welding, please set the
withdrawal length to be greater than the length of the wire.
To Next Page
Loading...