BodyCAP e Celsius Performance Connect - System Introduction; Ecelsius Performance Capsule; The Activator; The Button

10
P063GUI001 - User guide eCelsius Performance Connect.1 - EN
3. SYSTEM INTRODUCTION
The capsule eCelsius Performance (Fig. 1) is intented to be swallowed, with a glass of water. It has to be
woken up by the activator and associated to the ePerf Connect device to monitor core temperature.
The signaletic bracelet (Fig. 2) is worn to the wrist before the ingestion of the rst capsule and is removed
only after expulsion of the last one. A signaletic bracelet is provided with each capsule delivered. These
bracelets are in the same package than the capsules. They allow to inform the caregivers that the subject
swallowed a capsule and thus that it is forbiddden to perform an MRI exam.
Figure 1: eCelsius Performance capsule
Figure 2: Signaletic bracelet
eCelsius Performance capsule
In case of successive ingestion, the bracelet has to be removed after the expulsion of the last
capsule.
THE ACTIVATOR
The activator is intented to activate the eCelsius Performance capsule before a recording session.
Button OK
Hole to place the
capsule
Green LED
Micro-USB
connector
Figure 3: Description of the activator
The button ‘‘OK’’ is used to launch the activation process.
The activation process is detailed in ePerf Connect > Main functions > Activate a pill - page 17.
WARNING: Modication of the device forbidden
THE BUTTON