Bofan PT600X - Reset PT600 X to default; Output Control; Take photo at a preset time interval

18
one Mileage Alert for each 5000km mileage increments.
Set Odometer
Command
<password>SOD
Remarks
unit: 100 meters
Example
000000SOD or 000000SOD0: it is to set the tracker’s odometer to be ―0‖
000000SOD100: it is to set the tracker’s odometer to be 10km. (100*100meter=10000m=10km)
000000SOD5000: it is to set the tracker’s odometer to be 500km.(5000*100=500000m=500km)
Set time zone for tracker
Command
<password>TMZ<Time>
Remarks
Time from -13 to 13
Example
000000TMZ8 for set China time zone
NOTE
After setting time zone into tracker, you can get your local time in tracker reply message.
Restart
Command
<password>RST<Type>
Remarks
 Type=0 or null, to reboot PT600X
 Type=1 to reboot GPS
 Type=2 to reboot GSM
Reset PT600X to default
Command
<password>DFT
Remarks
DFT=Default
Request Power
Command
<password>RPO
Remarks
RPO=Request Power Voltage
Cut Power Alarm
Command
<password>CPA<Value>
Remarks
 Value=0 to disable Cut Power Alarm
 Value=1 to enable Cut Power Alarm
 Default set: 000000CPA1
Get IMEI
Command
<password>IME
Remarks
To get tracker’s IMEI number
Note: IMEI number can’t be tracker ID number.
Output Control
Command
<password>OPC<Index>,<Action>
Remarks
Index
 =1 means Out1
 =2 means Out2
 =3 means Out3
 =4 means Out4
Action
 =0 to close the output
 =1 to open the output
Take photo at a preset time interval
Command
<password>PTI<time interval>