Bogen NQ-A2060-G2 - Table 5. Configuration Settings (Standalone Disabled)

10
The Configuration Settings tab also displays the following information for each Device
Station attached to the amplifier:
Table 5. Configuration Settings (Standalone disabled)
Get Configuration from
Se
rver
Retrieves configuration settings (i.e., web username,
server, and local port) from the TFTP server specified in
the Network Settings (see
"Network Settings Tab Param-
e
ters” on page
6).
Web Username Displays the username of the current user.
Emergency-All-Call Identifies the IP address, port number, cut level (vol-
ume), and station list used for emergency all-call pages.
All-Call Identifies the IP address, port number, cut level (vol-
ume), and station list used for all-call pages.
Audio Distribution Identifies the IP address, port number, cut level (vol-
ume), and station list used for audio distribution.
Multicast # Identifies the IP address, port number, cut level (vol-
ume), and station list used for the multicast audio
st
ream of one (or more) zones.
Port Number Shows the output port of the amplifier, where 1 = A and 2
=
B.
Port Type Shows the device type to which the port connects.
Account ID Shows the SIP account (IP address) associated with the
de
vice preceded by the extension of the device associated
with this port.
Local Port Shows the port used for SIP.
Username Shows the username or extension for the station associ-
ated with the port.