3
Standalone Operation
This device can run in Standalone Operation mode, where it will not interact with a
Nyquist server (e.g., E7000 or C4000). This means the device will not:
• Fetch device configuration from Nyquist server
• Register with Nyquist server (via SIP)
• Store backup information to Nyquist server
• Allow access to Nyquist server-based NTP
Standalone Operation mode is ideal for scenarios that do not require the full functionality
pr
ovided by an integrated system, such as the Bogen C4000 or E7000 Series, but has the
ability to provide paging, multi-channel audio processing, and a SIP endpoint for a PBX/
VoIP phone system. It can be used to play music, audio, paging, and related functions.
Table 2. Appliance Dashboard Buttons
Dashboard Displays the d
ashboard.
Configuration Settings Accesses the Configuration Settings page,
where you
can view and set various options.If Standalone Opera-
tion is not enabled, you can also
r
eceive configuration
settings from a Nyquist server.
Network Settings Accesses the Network Settings page where you can view
an
d set network settings, such as the static IP address.
Firmware Update Accesses the Firmware Update page where you can view
th
e current Nyquist version, update firmware to a new
version, restore the configuration to factory defaults,
and reboot the appliance.
Logs Accesses log files, which record either events or mes-
sages that occur when software runs and are used when
tr
oubleshooting the appliance.
DSP Accesses the DSP page where you can view and set
pa
rameters for Digital Signal Processing (DSP).
Help Accesses the appliance’s online help.
Manual Displays the ap
pliance’s configuration manual.
Logout Logs out of the appliance’s dashboard.
To Next Page
Loading...
Need help?
General
