26
Delay
A delay effect causes the signal to be delayed by a configurable time interval from 0 to 30
milliseconds. This can be useful for synchronizing playback between different channels
which, for various reasons, may be playing out-of-sync.
Ratio Sets the compression ratio to be applied to the signal.
Fo
r example, if the ratio is set for 6 (6:1), the input signal
must increase by 6 dB for the output level to increase by
1 dB.
The range is 1 to 100.
Input meter Shows the strength of the input signal.
Output meter Shows the strength of the output signal, providing a
v
i
sual indicator of the effect of the compressor on the
output signal.
Comp LED Illuminates when compression is being applied to the
si
gnal.
Table 11. Co
mpressor Settings
To Next Page
Loading...
