EN
44
Extended menu
www.bora.com
i
If fan configuration was not successful, the slider
interface and the fan symbol will turn red.
Checking fan recognition
XX
Check that the system has recognised all fans correctly.
Indicator Colour Result
green 1 fan recognised
green 2 fans recognised
red 0 fans recognised, error (see the
Troubleshooting section)
Tab. 7.1 Possible results of the fan recognition
i
If a window contact switch is connected during fan
recognition, it must be taken into account that this will
also give approval (window open).
Aborting the basic configuration manually
XX
Long press on the menu button
If you wish to abort the basic configuration process ahead of
time, e.g. because fans are not correctly recognised, all menu
items that have not been fully completed must be run through
again at a later date.
Completing the basic configuration
When you have successfully completed all of the steps in the
basic configuration menu:
XX
Tap the flashing navigation button
XX
The system adopts and saves the settings made and the
standard display is shown.
7.2 Gas configuration menu
i
The burner nozzles, gas type, gas pressure and gas
characteristic curve may only be changed by a certified
engineer or BORA service technician. He/she also
assumes responsibility for the proper gas installation and
commissioning.
i
Correct settings are important for the safe, problem-free
operation of the gas cooktop.
i
You can find exact instructions on using the menu in the
Menu chapter.
Fig. 7.7 Selecting the lter type display
XX
Select the type of filter installed (tap the corresponding
segment on the slider ).
XX
Confirm and save the setting.
7.1.7 Menu item L:
Fan configuration
i
When configuring the fan, the type of fan installed and
the number of fans are automatically recognised by the
system and the configuration is adjusted accordingly.
During initial operation, the installer must check that the
fans have been recognised correctly.
Starting the fan configuration
Fig. 7.8 Starting the fan conguration display
XX
Touch the slider interface
XO
Fan configuration is started.
XO
During fan configuration the slider interface and the fan
symbol will flash.
i
When fan configuration is complete, the display will stop
flashing.
i
If fan configuration was successful, the slider interface
and the fan symbol will turn green.
To Next Page
Loading...
Need help?
General
