BORETTI BIKP-78 - Recall Function; Control Panel Locking

30
Recall Function
Afterswitchingoffthehob[0/I],itispossibletorecallthelastsettings.
• cookingstagesofallcookingzones(Booster)
• minutesandsecondsofprogrammedcookingzone-relatedtimers
•Automaticcooking
• Keepwarmfunction
The recall procedure is following:
• Pressthekey[0/I]
• Thensimultaneouslypressthe2zonesbackinlessthan6seconds.
The previous settings are again active.
« Keep warm » Function
This function allows to reach and maintain automatically a temperature of 42°C or 70°C.
Thiswillavoidliquidsoverowingandfastburningatthebottomofthepan.
•Toengage,tostartthefunction«Keepwarm»:
Action Control panel Display
Zoneselection Pressdisplay[0]selected [0]to[9]or[H]
42°C to engage Press on key [ U ] [ U ]
70°C to engage Press on key [ U ] [ U ]
 Tostop Slideonthe“SLIDER“ [0]to[9]or[H]
This function can be started independently on all the heating zones.
Whenthepanleavesthecookingzonethe“Keepwarm”functionremainsactiveduringapproximately10
minutes. The maximum duration of keeping warm is 2 hours.
Control panel locking
To avoid modification of the setting of the cooking zones , in particular during cleaning, the control
panelcanbelocked(withexceptiontotheOn/Offkey[0/I]).
•Lock:
Action Control panel Display
 Start pressonkey[0/I] [0]or[H]
 Lockingthehob Holdangeronthe“SLIDER” [L]
  andpress3timesonthe[P]
Oncethehoblocked,a10secondscountdownstarts.Duringthiscountdown,youcanunlockthehob.Once
past this time, the release becomes impossible, you must shut down and re-ignite the hob. At each selection
of [ P ] key, a segment of [ L ] appears. The hob is locked when the [ L ] is complete.