Bosch A4VG A4VG 32 Series User Manual

Transport and storage 31/68
RE 92003-01-B/12.2015, A4VG Series 32, Bosch Rexroth AG
A dismounted axial piston unit must be stored with corrosion protection for the
duration of storage.
The following instructions only refer to axial piston units which are operated with
a mineral oil-based hydraulic fluid. Other hydraulic fluids require preservation
methods that are specifically designed for them. In such cases, consult
BoschRexrothService, see Chapter10.5 “Spare parts” on page56 for
the address.
BoschRexroth recommends the following procedure:
1. Clean the axial piston unit, see Chapter10.1 “Cleaning and care” on page53.
2. Empty the axial piston unit.
3. For storage periods up to 12 months: Coat the inside of the axial piston unit with
mineral oil and fill with approx. 100 ml mineral oil.
For storage periods up to 24 months: Fill the axial piston unit with VCI 329
corrosion protection (20 ml).
Filling is done through the drain port T
1
or T
2
, see Chapter7.4 “Installing the axial
piston unit”, Fig. 15 to Fig. 17 on page44.
4. Plug all ports so they are airproof.
5. Moisten the unpainted areas of the axial piston unit with mineral oil or suitable,
easily removable corrosion protection, e.g., acid-free grease.
6. Package the axial piston unit with desiccant in corrosion protection film so it
is airproof.
7. Store the axial piston unit in a non-explosive area in a manner that is shock-proof,
see “Requirements” on page 30 in this chapter.
After removal

Bosch A4VG A4VG 32 Series Specifications

General

Brand	Bosch
Model	A4VG A4VG 32 Series
Category	Water Pump
Language	English