Bosch AMAX panel 4000 - Status Indicator; Test

Example : Data Bus Location 103 - DIP Settings
On
Off
Figure 5.5: DX2010 DIP Switch Settings
Status Indicator
– Flashing once per second: Indicating normal operation.
– Constant illumination indicates following conditions:
– The grounding conductor is not connected or there is communication failure between the
alarm control panel and the module.
– No zones are distributed to modules with corresponding addresses.
– Module address setting error.
– Off: The module is de-Energized.
DIP Switch
Status Indicator
Figure 5.6: DX2010 Status Indicators
Test
The alarm control panel tests the communication normally with the module. In case of
communication failure, a fault report with the module address is sent.
5.2.5
5.2.6
16 en | Optional Modules and Peripheral Devices
AMAX panel 4000 / AMAX panel 4000
EN
2013.07 | 03 | F.01U.267.112 Installation Guide Bosch Sicherheitsysteme GmbH